Okay, don't know for sure if this is a bug or not but i wanted to know if we can do something about this.
I'm using MePo 1.6, and have a Sharp 46" 1080p LCD. I have dynamic refresh rate enabled and have set the default to PALHD which is 50hz.
When i'm watching a movie it switches to 24hz and runs fine. If i manually stop the movie it switches back to 50hz.
But! If i'm watching a movie and press the powerbutton so the system goes to sleep, it wakes up with the 24hz setting still active. It referts to the movie details, doesn't resume playback (which i find just fine!) but my wife now want's to watch TV, the system doesn't switch to 50hz when the tv comes online. Obiously this results in bad playback.
If i would start a movie, and stop it, then it reverts to 50hz. And the playback of the TV is smooth again?
Does this make sense?
I've added logs where these events take place.
Sart mepo (50hz)
Start movie (24hz)
standby
resume
watch tv (24hz)
I'm using MePo 1.6, and have a Sharp 46" 1080p LCD. I have dynamic refresh rate enabled and have set the default to PALHD which is 50hz.
When i'm watching a movie it switches to 24hz and runs fine. If i manually stop the movie it switches back to 50hz.
But! If i'm watching a movie and press the powerbutton so the system goes to sleep, it wakes up with the 24hz setting still active. It referts to the movie details, doesn't resume playback (which i find just fine!) but my wife now want's to watch TV, the system doesn't switch to 50hz when the tv comes online. Obiously this results in bad playback.
If i would start a movie, and stop it, then it reverts to 50hz. And the playback of the TV is smooth again?
Does this make sense?
I've added logs where these events take place.
Sart mepo (50hz)
Start movie (24hz)
standby
resume
watch tv (24hz)