As promised.
Please test if you can.
Any channels that have been searched before should work however I cannot guarantee that they will so I recommend a fresh installation.
This will install over the top of 1.3.0 Alpha only.
To enable USALS go into your Diseqc Motor. Tick the Enable Usals(gotoX).
Enter your Latitude and Longitude. You can find out what it is from this website. http://itouchmap.com/latlong.html
Make sure you use the correct details.
North is a positive number 0 - 90. South is a negative number -0.01 to -90.
East is a positive number 0 - 180. West is a negative number -0.01 to -180.
Then to test select a Satellite in the drop down box then click goto.
The dish should move to the corresponding satellite.
Now go into the scan page. Select the Satellite you wish to search then click scan. The dish will move to the satellite and scan it. Repeat this process for all your satellites.
There is a wait time for the first satellite movement of 25 seconds to stop the "No signal" error. Every subsequent motor move will have a wait time of 750ms per degree. I will be adding a box to increase this so you shouldn't get any No Signal errors.
All feedback is welcomed.
Please test if you can.
Any channels that have been searched before should work however I cannot guarantee that they will so I recommend a fresh installation.
This will install over the top of 1.3.0 Alpha only.
To enable USALS go into your Diseqc Motor. Tick the Enable Usals(gotoX).
Enter your Latitude and Longitude. You can find out what it is from this website. http://itouchmap.com/latlong.html
Make sure you use the correct details.
North is a positive number 0 - 90. South is a negative number -0.01 to -90.
East is a positive number 0 - 180. West is a negative number -0.01 to -180.
Then to test select a Satellite in the drop down box then click goto.
The dish should move to the corresponding satellite.
Now go into the scan page. Select the Satellite you wish to search then click scan. The dish will move to the satellite and scan it. Repeat this process for all your satellites.
There is a wait time for the first satellite movement of 25 seconds to stop the "No signal" error. Every subsequent motor move will have a wait time of 750ms per degree. I will be adding a box to increase this so you shouldn't get any No Signal errors.
All feedback is welcomed.