Recent content by D4bFz3awSRYHKjr3

Sorry, I think I never implemented that, and won't be doing either, I just looked and I have thrown my source files away. So development is dead.

Development is stopped, merging channels with the same Displayname is not possible

In CONFIG1 you put a few different 'DOWNLOAD=' or 'LOCAL=' SAVETO=C:\tvguide.xml ->Where the files should be saved and the name WRITECHANNELLIST=C:\channels.txt ->Writes a list with al the channels found in the provided xml files, useful for creating CHANNELKEEP1 and CHANNELREMOVE1...

Try using the attached xmltv.dtd file instead of the one that is being downloaded.

do you actually have 'I15.751387.microsoft.com' in your file? Can you see a file called xmltv.dtd? By the way for everybody, at the beginning of the console output, you can see where the log file is stored. But it's basically the same as the console output.

OK, I found the problem, the problem is in the file itself, they use the wrong encoding as far as I know, because when you change utf-8 to ISO-8859-2, the problem is gone. The reason that it doesn't happen in FTR is probably that they do it in a different way and are way better programmers...

i'll try and play with it and see what I can do about it

can you look it up and tell me wich character it is, also post a small part of the area that gives the error. you previously gave me a line number, but I couldnt find anything at that time

Re: SAF v5.00 experimental (based on FFDShow DXVA decoder) do you have setup your codec configuration properly in MP setup?

Re: SAF v5.00 experimental (based on FFDShow DXVA decoder) I can enable them, but I have no hardware to send dts-ma and dd-thd to my receiver, for the moment I'm only using optical out no hdmi. So I can't tell you if that works, but DTS and DD work 100%

Does this happen all the time? No, there is no direct command to do this You can import all guides with 1 config, just make sure that IDCHECK=TRUE is used. I have no interest to implement some error detection that will skip that one line, when something is wrong, this would require a lot...

Re: SAF v5.00 experimental (based on FFDShow DXVA decoder) DTS passthrough is working here with saf 5.00, did you enable it? see screenshot I'm not using any postprocessing in MP itself, just answerd the right questions during saf install and that was it.

Next to the exe there should be 2 dll's, tvcontrol and tvlibrary.interfaces, perhaps that's why it doesn't work....

See the frontpage in a minute, I've uploaded the source file so that you can add themselves.

try replacing the included dll's with new ones from rc1