Reply to thread

Message

<blockquote data-quote="zoee" data-source="post: 173866" data-attributes="member: 54780">I updated to the latest test version (2007-08-21) and did some testing. I am using the translator at the same time so I created a new program mapping for MP with &quot;Ignore system-wide mappings&quot; selected. Unfortunately that didn't make any difference to the problem (I did make sure the option was taking effect though). So I decided to just run IR Server on its own to get a clean test. I have attached a clean log from startup with five up arrow presses and five down arrow presses. Both of the sets contained two double inputs so it was seven in each direction in MP. Looking at the log I see seven entries for each direction. So I guess that must help you understand where this might be going wrong. This was with 500 initial delay and 150 held delay.Again, thanks for all your hard work!Edit: During further testing it is clear that this is for all buttons, not just arrows. Also it seams that if I press the buttons on the remote really quickly there are much fewer double inputs. Perhaps this is a hardware issue?</blockquote>

[QUOTE="zoee, post: 173866, member: 54780"] I updated to the latest test version (2007-08-21) and did some testing. I am using the translator at the same time so I created a new program mapping for MP with "Ignore system-wide mappings" selected. Unfortunately that didn't make any difference to the problem (I did make sure the option was taking effect though). So I decided to just run IR Server on its own to get a clean test. I have attached a clean log from startup with five up arrow presses and five down arrow presses. Both of the sets contained two double inputs so it was seven in each direction in MP. Looking at the log I see seven entries for each direction. So I guess that must help you understand where this might be going wrong. This was with 500 initial delay and 150 held delay. Again, thanks for all your hard work! Edit: During further testing it is clear that this is for all buttons, not just arrows. Also it seams that if I press the buttons on the remote really quickly there are much fewer double inputs. Perhaps this is a hardware issue? [/QUOTE]

Verification