Reply to thread

Message

<blockquote data-quote="pantav" data-source="post: 750574" data-attributes="member: 86782">Yes, I appended the question to another thread, but after this i thinked about start a new trhread and not invade the other. Today I watched the two responses. I continue in this thread. Well the AVIVO transcoding software is only a wizard in the ATI control panel (drop source-&gt; select profile-&gt; transcode). I searched in the registry and only found a key named filterdata for all the directshow filters. But I don't now if the defaults are saved or not here.Yes. The filter has a property page with tabs (both filters, video and audio encoder), and I can configure all the settings in this page. But I can't change the defaults, only for a concrete graphic in GraphicStudio the changes remains, but not for new graphics. The same behavior is showed by Avermedia MPeg2 Encoder and Microsoft Mpeg2 Encoder.Maybe is possible to save this property page in MP, or use the ICodecAPI interface GetAllSettings and SetAllSettings to allow a generic configuration option for any codec. Or I can save a graph with only this filter but configured. Sorry i this has not sense, I explored a little searching a solution but i had zero experience with DirectShow.Thank's for both responses.</blockquote>

[QUOTE="pantav, post: 750574, member: 86782"] Yes, I appended the question to another thread, but after this i thinked about start a new trhread and not invade the other. Today I watched the two responses. I continue in this thread. Well the AVIVO transcoding software is only a wizard in the ATI control panel (drop source-> select profile-> transcode). I searched in the registry and only found a key named filterdata for all the directshow filters. But I don't now if the defaults are saved or not here. Yes. The filter has a property page with tabs (both filters, video and audio encoder), and I can configure all the settings in this page. But I can't change the defaults, only for a concrete graphic in GraphicStudio the changes remains, but not for new graphics. The same behavior is showed by Avermedia MPeg2 Encoder and Microsoft Mpeg2 Encoder. Maybe is possible to save this property page in MP, or use the ICodecAPI interface GetAllSettings and SetAllSettings to allow a generic configuration option for any codec. Or I can save a graph with only this filter but configured. Sorry i this has not sense, I explored a little searching a solution but i had zero experience with DirectShow. Thank's for both responses. [/QUOTE]

Verification