Reply to thread

Message

<blockquote data-quote="kszabo" data-source="post: 562471" data-attributes="member: 61646">There are several ways to get your goal.First you have to identify the audio codec in use, for several audio formats (it can happen that ffdshow-audio is loaded for MP3, AC3filter for AC3 or DTS etc., it can be done with Graphstudio). Try to get a MePo codec configuration of your liking and configure the output of the used codec to 2.0 stereo (quite simple task for ffdsow audio or AC3, just open the config window of these). No postprocessing needed (but also a possible solution, maybe better if you need this only temporarily).I have no idea of your setup (installed codecs), but the 1st thing I would do is to install latest ffdshow codec (during installation choose 2.0 stereo). Start audio config, set it up to your likings, like &quot;mixer&quot; set to stereo. There you can configure your surround-to-stereo downmix. You can even make your own matrix (eg. give the center speakers more volume) like here: <a href="http://beginwithsoftware.com/videoguides/mkv-h264-to-vc-1/005_ffdshow_Audio_Decoder_6_Channels_Configuration.png" target="_blank">http://beginwithsoftware.com/videoguides/mkv-h264-to-vc-1/005_ffdshow_Audio_Decoder_6_Channels_Configuration.png</a>Greetings</blockquote>

[QUOTE="kszabo, post: 562471, member: 61646"] There are several ways to get your goal. First you have to identify the audio codec in use, for several audio formats (it can happen that ffdshow-audio is loaded for MP3, AC3filter for AC3 or DTS etc., it can be done with Graphstudio). Try to get a MePo codec configuration of your liking and configure the output of the used codec to 2.0 stereo (quite simple task for ffdsow audio or AC3, just open the config window of these). No postprocessing needed (but also a possible solution, maybe better if you need this only temporarily). I have no idea of your setup (installed codecs), but the 1st thing I would do is to install latest ffdshow codec (during installation choose 2.0 stereo). Start audio config, set it up to your likings, like "mixer" set to stereo. There you can configure your surround-to-stereo downmix. You can even make your own matrix (eg. give the center speakers more volume) like here: [URL="http://beginwithsoftware.com/videoguides/mkv-h264-to-vc-1/005_ffdshow_Audio_Decoder_6_Channels_Configuration.png"]http://beginwithsoftware.com/videoguides/mkv-h264-to-vc-1/005_ffdshow_Audio_Decoder_6_Channels_Configuration.png[/URL] Greetings [/QUOTE]

Verification