home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
MediaPortal 1 Plugins
Basic Home Automation via xAP BSC enabled devices (updated 9-01-2008)
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="patrick" data-source="post: 111303" data-attributes="member: 12502"><p>If you are running HS 1.x I think you need to put hspi_xAP.ocx file in </p><p>the HomeSeer folder (sounds like you did that).</p><p></p><p>At a command prompt, navigate to your HS folder and register </p><p>the OCX file using the following:</p><p>%windir%\system32\regsvr32 hspi_xAP.ocx</p><p></p><p>Start Homeseer and go to the page where interfaces are </p><p>installed and look for the xAP Conduit and enable it. </p><p></p><p></p><p>HTH,</p><p>patrick</p></blockquote><p></p>
[QUOTE="patrick, post: 111303, member: 12502"] If you are running HS 1.x I think you need to put hspi_xAP.ocx file in the HomeSeer folder (sounds like you did that). At a command prompt, navigate to your HS folder and register the OCX file using the following: %windir%\system32\regsvr32 hspi_xAP.ocx Start Homeseer and go to the page where interfaces are installed and look for the xAP Conduit and enable it. HTH, patrick [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
MediaPortal 1 Plugins
Basic Home Automation via xAP BSC enabled devices (updated 9-01-2008)
Contact us
RSS
Top
Bottom
