Reply to thread

Message

<blockquote data-quote="patrick" data-source="post: 151819" data-attributes="member: 12502">ronsonol,Think I found the problem with recognizing the dim levels after a command.It was in handling the RecvAction sent after a command. I could not tell from your post but are the level commands (up/down) working(when the correct level is detected <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite1" alt=":)" title="Smile&nbsp; &nbsp; :)" loading="lazy" data-shortname=":)" /> )?For example, when dim level 80 is detected, are you able to change it to 70 or 90?The toggle comes from xAP. It supports the toggle command natively.I could only get four buttons to look right in the skin, five made them look too small. So, for &quot;level devices&quot; I had to decide between up/down/on/off and up/down/toggle.(Although my graphics skills are so bad it was difficult to get a button to represent any of them much less toggle.)Thanks again!patrick</blockquote>

[QUOTE="patrick, post: 151819, member: 12502"] ronsonol, Think I found the problem with recognizing the dim levels after a command. It was in handling the RecvAction sent after a command. I could not tell from your post but are the level commands (up/down) working (when the correct level is detected :) )? For example, when dim level 80 is detected, are you able to change it to 70 or 90? The toggle comes from xAP. It supports the toggle command natively. I could only get four buttons to look right in the skin, five made them look too small. So, for "level devices" I had to decide between up/down/on/off and up/down/toggle. (Although my graphics skills are so bad it was difficult to get a button to represent any of them much less toggle.) Thanks again! patrick [/QUOTE]

Verification