Reply to thread

Message

<blockquote data-quote="patrick" data-source="post: 152038" data-attributes="member: 12502">ronsonol,I did not get a chance to work on it last night or this morning, will try this afternoon.Question on the cm15a and reboots. So even if the queryplc is run after a reboot the correct status will not be returned until an On or Off? Want me to see if I can add an option to send OFF to unknown devices at startup (it would be specific and not include xAP)?Also I will look into the device updates for level devices, that is strange b/c it works the same for both binary and level devices, probably a coding error by me.I will look into unknown devices defaulting to OFF.You would never be able to detect an unknown or error state. I was thinking about something like a door, with an error/unknown you might decide to check it, but with a state reported you would assume thatreflected the true state and leave you garage door open all night.(You might just be able to set the state unknown reporting to display OFF and change the unknown image to a copy of the off/level 0 image.)Thanks,patrick</blockquote>

[QUOTE="patrick, post: 152038, member: 12502"] ronsonol, I did not get a chance to work on it last night or this morning, will try this afternoon. Question on the cm15a and reboots. So even if the queryplc is run after a reboot the correct status will not be returned until an On or Off? Want me to see if I can add an option to send OFF to unknown devices at startup (it would be specific and not include xAP)? Also I will look into the device updates for level devices, that is strange b/c it works the same for both binary and level devices, probably a coding error by me. I will look into unknown devices defaulting to OFF. You would never be able to detect an unknown or error state. I was thinking about something like a door, with an error/unknown you might decide to check it, but with a state reported you would assume that reflected the true state and leave you garage door open all night. (You might just be able to set the state unknown reporting to display OFF and change the unknown image to a copy of the off/level 0 image.) Thanks, patrick [/QUOTE]

Verification