Reply to thread

Message

<blockquote data-quote="Collective" data-source="post: 920159" data-attributes="member: 79277">&quot;5. 3dtv.at Stereoscopic Player is not prerequisite. It's filter is. (just a dll).&nbsp;In your original post #1, you used to state that stereoscopic player was a requirement BECAUSE of the filters and gave a link to the trial version.You have since edited this first post[DOUBLEPOST=1349098833][/DOUBLEPOST]&quot;2. I am just saying that if DXVA needs 3dtv.at Renderer, do not get your hopes up until MP (or somebody) supports the renderer&quot;&nbsp;I said the stereo transformation filter supports DXVA&nbsp;[ATTACH=full]112089[/ATTACH]&nbsp;The problem I seem to have is that with version 1.8 of stereoscopic player, the output selection does not SAVE. It always returns to 'source'This is where reading settings from an SVI file would be helpful&nbsp;-----------25 minutes later-------------------installed the 1.81 update and now both input and output settings won't save, but it actually applied settings in MPC-HC and I got 3d working there (but not with every 3d file), but have to manually set config every time.</blockquote>

[QUOTE="Collective, post: 920159, member: 79277"] "5. 3dtv.at Stereoscopic Player is not prerequisite. It's filter is. (just a dll). In your original post #1, you used to state that stereoscopic player was a requirement BECAUSE of the filters and gave a link to the trial version. You have since edited this first post[DOUBLEPOST=1349098833][/DOUBLEPOST]"2. I am just saying that if DXVA needs 3dtv.at Renderer, do not get your hopes up until MP (or somebody) supports the renderer" I said the stereo transformation filter supports DXVA [ATTACH=full]112089[/ATTACH] The problem I seem to have is that with version 1.8 of stereoscopic player, the output selection does not SAVE. It always returns to 'source' This is where reading settings from an SVI file would be helpful -----------25 minutes later------------------- installed the 1.81 update and now both input and output settings won't save, but it actually applied settings in MPC-HC and I got 3d working there (but not with every 3d file), but have to manually set config every time. [/QUOTE]

Verification