Reply to thread

Message

<blockquote data-quote="cheetah05" data-source="post: 270604" data-attributes="member: 19628">I know how to pair properly now, I have got my remote to properly pair....never looses connection too (unless it goes out of range). I can see this a problem and will how to find a way to make an API call to disconnect the remote when MP exits. To connect the remote to the PC, you simply press the playstation key in the center of the remote.I know what i need to do (how to get it work), but don't yet have the programming knowledge to do it.....====================1. To pair you need to go through the standard Microsoft device, so that you see it in the Devices section.2. Select the device and click properties and you should see the following screen:3. Make the controller discoverable again by pressing [Start &amp; Enter Keys] on the remote (together).4. Click the services tab.5. Wait till it has found the services and then make sure you check the HID service and click ok as seen below:It will now be registered as a HID device and will appear under &quot;Game Controllers&quot;.To get it to work in MP, I need to find a way to read the HID messages it sends.</blockquote>

[QUOTE="cheetah05, post: 270604, member: 19628"] I know how to pair properly now, I have got my remote to properly pair....never looses connection too (unless it goes out of range). I can see this a problem and will how to find a way to make an API call to disconnect the remote when MP exits. To connect the remote to the PC, you simply press the playstation key in the center of the remote. I know what i need to do (how to get it work), but don't yet have the programming knowledge to do it..... ==================== 1. To pair you need to go through the standard Microsoft device, so that you see it in the Devices section. 2. Select the device and click properties and you should see the following screen: 3. Make the controller discoverable again by pressing [Start & Enter Keys] on the remote (together). 4. Click the services tab. 5. Wait till it has found the services and then make sure you check the HID service and click ok as seen below: It will now be registered as a HID device and will appear under "Game Controllers". To get it to work in MP, I need to find a way to read the HID messages it sends. [/QUOTE]

Verification