Reply to thread

Message

<blockquote data-quote="mark3141" data-source="post: 1023254" data-attributes="member: 117463">Hi,&nbsp;I've recently attempted to use this but haven't been able to get any channels.&nbsp; I've set my scan to 60 secs and once the scan is complete, it says 'out of band service information... signal locked, no channels found.'&nbsp; &nbsp;I'm using an HDHomerun Prime w/ CABLECard from Verizon FIOS.&nbsp; I assume the initial install went ok as I get a total of six tuners (the three tuners duplicated as mentioned in the instructions).&nbsp; However, I cannot enable the HDHR Prime Tuners without having the Silicon HDHR Tuners enabled.&nbsp; For some reason, when I disable the three Silicondust HDHR Tuners (as recommended in the set-up), all tuners associated with the HDHR disappear from the sub-menu below my server.&nbsp; I can see them in the menu to enable/disable tuners, but I cannot bring them up to run a channel scan.&nbsp; I have to re-enable them and restart the configuration to run a scan.&nbsp; &nbsp;I also tried scanning these with preferred network changed from generic to ATSC with no luck.&nbsp; Once I made that change, like above, the tuners would disappear from the menu unless I restarted the configuration.&nbsp; Note that I've tried a fresh install of the HDHR and Mediaportal.&nbsp;Logs are attached...hopefully, I'm just doing something dumb.</blockquote>

[QUOTE="mark3141, post: 1023254, member: 117463"] Hi, I've recently attempted to use this but haven't been able to get any channels. I've set my scan to 60 secs and once the scan is complete, it says 'out of band service information... signal locked, no channels found.' I'm using an HDHomerun Prime w/ CABLECard from Verizon FIOS. I assume the initial install went ok as I get a total of six tuners (the three tuners duplicated as mentioned in the instructions). However, I cannot enable the HDHR Prime Tuners without having the Silicon HDHR Tuners enabled. For some reason, when I disable the three Silicondust HDHR Tuners (as recommended in the set-up), all tuners associated with the HDHR disappear from the sub-menu below my server. I can see them in the menu to enable/disable tuners, but I cannot bring them up to run a channel scan. I have to re-enable them and restart the configuration to run a scan. I also tried scanning these with preferred network changed from generic to ATSC with no luck. Once I made that change, like above, the tuners would disappear from the menu unless I restarted the configuration. Note that I've tried a fresh install of the HDHR and Mediaportal. Logs are attached...hopefully, I'm just doing something dumb. [/QUOTE]

Verification