Reply to thread

Message

<blockquote data-quote="kiwi_fella" data-source="post: 493638" data-attributes="member: 96279">Greetings, i'm new to MP and must say so far i'm impressed. I'm running Athlon X64 3600 4GB DDR2 1TB storage, HVR3000 &amp; Nova-s PLus dvbs, Graphcs is Gigabyte 9400Gt. I've recently had a nice new 90cm dish installed with lnb's setup for Optus d1 and Intelsat2. In a normal set top box they work fine. First problem was Nova wouldnt fre the Diseqc switch to alternate LNB's so scrapped it for a tone swtich which runs on thefollowing settings. Sat 1 C-Band 169 Degrees Inelsat 2,5Sat 2 NA Custom 2 160Degrees Optus D1Override FreqLNB Low (LOF1) 05150LNB High (LOF2) 11300LNB Switch Freq (LNBSW) 06000Using simpleA/B Diseqc settings, with C-Band being A. DVB-T sets up fine in MP 1.1.0.0 A, however is only dragging about one hours EPG. If i connect ONLY the DVB-S side of the HVR3000 it wil switch between two LNB's fien, but as soon as i setup the DVB-T its all over and it will recieve DVB-T fine but wont swtich to DVB-S channels. So so far i'm looking at running DVB-S leads out to each LNB individually, but that seems stupid.....HELP!!!Brian</blockquote>

[QUOTE="kiwi_fella, post: 493638, member: 96279"] Greetings, i'm new to MP and must say so far i'm impressed. I'm running Athlon X64 3600 4GB DDR2 1TB storage, HVR3000 & Nova-s PLus dvbs, Graphcs is Gigabyte 9400Gt. I've recently had a nice new 90cm dish installed with lnb's setup for Optus d1 and Intelsat2. In a normal set top box they work fine. First problem was Nova wouldnt fre the Diseqc switch to alternate LNB's so scrapped it for a tone swtich which runs on thefollowing settings. Sat 1 C-Band 169 Degrees Inelsat 2,5 Sat 2 NA Custom 2 160Degrees Optus D1 Override Freq LNB Low (LOF1) 05150 LNB High (LOF2) 11300 LNB Switch Freq (LNBSW) 06000 Using simpleA/B Diseqc settings, with C-Band being A. DVB-T sets up fine in MP 1.1.0.0 A, however is only dragging about one hours EPG. If i connect ONLY the DVB-S side of the HVR3000 it wil switch between two LNB's fien, but as soon as i setup the DVB-T its all over and it will recieve DVB-T fine but wont swtich to DVB-S channels. So so far i'm looking at running DVB-S leads out to each LNB individually, but that seems stupid..... HELP!!! Brian [/QUOTE]

Verification