Reply to thread

Hi again

The way IR commands are mapped to channels is by:

1. Setting the channel number in the tuning details for each of the channels that you've created. The channel number will be the number that you key in on your remote to switch to the channel. It will also be the number that your IR blaster sends to the Sky box.

2. Configure the blaster to send commands that the box understands. It sounds like you've done this correctly.

This seems contradictory to what you said earlier because passing through number commands is exactly how an IR blasting setup works. Could you explain what you mean by "seamlessly" in a little more depth so we are both on the same page...

mm