Reply to thread

Message

<blockquote data-quote="errfoil" data-source="post: 1299838" data-attributes="member: 68285">When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner:&quot;Source: HDMI 1Not supported&quot;When I select BluRay or XBox everything is normal.My video card is a GTX 1050 which is HDMI 2.0b, which supports 2160 at 60hz. My AVR is an Onkyo RZ50.My front end is MediaPortal 1.34. I tried turning off Dynamic Refresh Rate and even deleting the 23.9 refresh rate option. The codecs are standard; all LAV for both video and audio. Unfortunately I don't have any logs because I can't see the screen when everything is running.Any ideas on where to go next?</blockquote>

[QUOTE="errfoil, post: 1299838, member: 68285"] When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner: "Source: HDMI 1 Not supported" When I select BluRay or XBox everything is normal. My video card is a GTX 1050 which is HDMI 2.0b, which supports 2160 at 60hz. My AVR is an Onkyo RZ50. My front end is MediaPortal 1.34. I tried turning off Dynamic Refresh Rate and even deleting the 23.9 refresh rate option. The codecs are standard; all LAV for both video and audio. Unfortunately I don't have any logs because I can't see the screen when everything is running. Any ideas on where to go next? [/QUOTE]

Verification