Normal
[USER=113164]@Rob Hexenmeister[/USER]Thanks for responding. I realized that that was the only way and did the same using the FLIRC profile for Microsoft WMC. Since the Microsoft WMC RC6 remote control has standardized key codes, I would have expected these to be already included in the profile. I would have preferred that, because I know from my experience with programming my Xsight Touch that programmed codes are more reliable than learned ones. The FLIRC Microsoft WMC profile has 8 buttons fewer than the remote I got with my FSC Scaleo E. In particular, the colored buttons (red, yellow, green and blue) have been combined with the media selection buttons: these are separate on my RC6 remote. The FLIRC GUI Advanced settings mentions a FLIRC WMC profile as well as the MS one, but I couldn't find any way to invoke it.Since MediaPortal can use WMC RC6 commands directly, I never had to "muck about with selecting and configuring remote controls in the MP Configuration." In older MP versions there was a dedicated MCE Remote option. In newer versions, I just use "Enable HID" and everything works.
[USER=113164]@Rob Hexenmeister[/USER]
Thanks for responding. I realized that that was the only way and did the same using the FLIRC profile for Microsoft WMC. Since the Microsoft WMC RC6 remote control has standardized key codes, I would have expected these to be already included in the profile. I would have preferred that, because I know from my experience with programming my Xsight Touch that programmed codes are more reliable than learned ones. The FLIRC Microsoft WMC profile has 8 buttons fewer than the remote I got with my FSC Scaleo E. In particular, the colored buttons (red, yellow, green and blue) have been combined with the media selection buttons: these are separate on my RC6 remote. The FLIRC GUI Advanced settings mentions a FLIRC WMC profile as well as the MS one, but I couldn't find any way to invoke it.
Since MediaPortal can use WMC RC6 commands directly, I never had to "muck about with selecting and configuring remote controls in the MP Configuration." In older MP versions there was a dedicated MCE Remote option. In newer versions, I just use "Enable HID" and everything works.
