Reply to thread

Message

<blockquote data-quote="McChots" data-source="post: 522345" data-attributes="member: 23647">Ok lets see...I have a hauppauge blaster but it doesn't work so I had to get the MCE remote. I still use the Hauppauge remote as I prefer the button layout.Check this wiki entry:<a href="http://wiki.team-mediaportal.com/IRServerSuite/TVE3%20Blaster%20plugin" target="_blank">IRServerSuite/TVE3 Blaster plugin</a> to configure the IRServerSuite for blasing.I use the second channel(a whole other issue) on a dual view decoder so I had to manually teach the IR codes for each button. I only use the 0-9 codes anyway. First go to &quot;IR Commands&quot; and create a new file for each button. Then go to &quot;STB Setup&quot; on the &quot;Plugin Setup&quot; page. You want to set it up so that for each external digit command, you select the corresponding IR command that you created. I think there might be some profiles for DSTV under the Quick Setup that you could try instead. If the blaster does not change the channel, you can test to see if it is working with a camera phone. Just point the IR leds at the camera and you should see it flashing.If you can't figure it out, give some more details on your setup and what you've done so far and we'll take it from there. you can also check <a href="http://wiki.team-mediaportal.com/IRServerSuite/SetTopBox%20blasting%20in%20MediaPortal" target="_blank">SetTopBox blasting in MediaPortal</a></blockquote>

[QUOTE="McChots, post: 522345, member: 23647"] Ok lets see... I have a hauppauge blaster but it doesn't work so I had to get the MCE remote. I still use the Hauppauge remote as I prefer the button layout. Check this wiki entry:[URL="http://wiki.team-mediaportal.com/IRServerSuite/TVE3%20Blaster%20plugin"]IRServerSuite/TVE3 Blaster plugin[/URL] to configure the IRServerSuite for blasing. I use the second channel(a whole other issue) on a dual view decoder so I had to manually teach the IR codes for each button. I only use the 0-9 codes anyway. First go to "IR Commands" and create a new file for each button. Then go to "STB Setup" on the "Plugin Setup" page. You want to set it up so that for each external digit command, you select the corresponding IR command that you created. I think there might be some profiles for DSTV under the Quick Setup that you could try instead. If the blaster does not change the channel, you can test to see if it is working with a camera phone. Just point the IR leds at the camera and you should see it flashing. If you can't figure it out, give some more details on your setup and what you've done so far and we'll take it from there. you can also check [URL="http://wiki.team-mediaportal.com/IRServerSuite/SetTopBox%20blasting%20in%20MediaPortal"]SetTopBox blasting in MediaPortal[/URL] [/QUOTE]

Verification