home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
Products
IR Server Suite (IRSS)
Control TV via serial cable
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MTBikerTim" data-source="post: 171222" data-attributes="member: 54432"><p>Thanks jburnette and and-81. </p><p></p><p>To jburnette thank you, of course the source code is on source forge. I'll use the excuse again that it was too early in the morning.</p><p></p><p>Hi and-81 the serial interface on the TV is fairly well documented. I have attached the manual. I am obviously missing something though as my interpretation of what the manual says to send the tv to get it to power on and off gives strange results. If anyone would like to give me there interpretation I would appreciate it. I am just using the test button in the serial command section of your plug-in and I have tried writing my own code but both have the same results. The TV is set to set ID 1. When I send a command like "ka 1 \h0xff\r" the tv is just as likely to turn off or do nothing as it is to return it's status.</p></blockquote><p></p>
[QUOTE="MTBikerTim, post: 171222, member: 54432"] Thanks jburnette and and-81. To jburnette thank you, of course the source code is on source forge. I'll use the excuse again that it was too early in the morning. Hi and-81 the serial interface on the TV is fairly well documented. I have attached the manual. I am obviously missing something though as my interpretation of what the manual says to send the tv to get it to power on and off gives strange results. If anyone would like to give me there interpretation I would appreciate it. I am just using the test button in the serial command section of your plug-in and I have tried writing my own code but both have the same results. The TV is set to set ID 1. When I send a command like "ka 1 \h0xff\r" the tv is just as likely to turn off or do nothing as it is to return it's status. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Products
IR Server Suite (IRSS)
Control TV via serial cable
Contact us
RSS
Top
Bottom
