home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
Installation, configuration support
Diseqc switch setup guide for dummies, please help!
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="HappySwede" data-source="post: 612133" data-attributes="member: 54648"><p>I have played around with the scanning again and I think I am on to something but I am not completly sure. What I did was to only change the satelite setting and scaning the LNBs one by one set to Hotbird without changing Diseqc settings. The scan as far as I see comes back identical, meaning that when I scan one LNB with the correct settings for satelite it might go through half the scan before finding anythin. When set to Hotbird and scaning any LNB I get a signal from the first transponder and what looks like the amount of channels found on the actual Hotbird. In other words It looks like its not actually changing LNB but just scanning the same one with different transponder lists.</p><p>Could this be correct and if so, what to do about it?</p></blockquote><p></p>
[QUOTE="HappySwede, post: 612133, member: 54648"] I have played around with the scanning again and I think I am on to something but I am not completly sure. What I did was to only change the satelite setting and scaning the LNBs one by one set to Hotbird without changing Diseqc settings. The scan as far as I see comes back identical, meaning that when I scan one LNB with the correct settings for satelite it might go through half the scan before finding anythin. When set to Hotbird and scaning any LNB I get a signal from the first transponder and what looks like the amount of channels found on the actual Hotbird. In other words It looks like its not actually changing LNB but just scanning the same one with different transponder lists. Could this be correct and if so, what to do about it? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
Installation, configuration support
Diseqc switch setup guide for dummies, please help!
Contact us
RSS
Top
Bottom
