home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Development
Submit: code patches (MediaPortal/TV-Server/etc.)
DVB EPG Grab delay in seconds
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="arion_p" data-source="post: 867867" data-attributes="member: 45945"><p>Not sure why it was set in minutes. But what I'm after is that if a user has configured 5 minutes (or even 1 minute) he has done it for a reason (perhaps it uses too many resources). On upgrade this will be changed to 5 seconds (or 1 second) behind his back which is not what the user configured. We have to respect the user configured values and any upgrade should not change them arbitrarily unless there is a very good reason for doing so.</p><p> </p><p>In the above case what would happen if user configure 1minute and we essentially change that to 1 second? Is 1 second enough to grab EPG for say 2000 channels on DVBS? As far as I can tell from TsWriter code, EPG grabber sends data back to TVServer after there has been no epg data packets fro 1 minute, so setting a timeout < 1minute will essentially always abort the grab.</p></blockquote><p></p>
[QUOTE="arion_p, post: 867867, member: 45945"] Not sure why it was set in minutes. But what I'm after is that if a user has configured 5 minutes (or even 1 minute) he has done it for a reason (perhaps it uses too many resources). On upgrade this will be changed to 5 seconds (or 1 second) behind his back which is not what the user configured. We have to respect the user configured values and any upgrade should not change them arbitrarily unless there is a very good reason for doing so. In the above case what would happen if user configure 1minute and we essentially change that to 1 second? Is 1 second enough to grab EPG for say 2000 channels on DVBS? As far as I can tell from TsWriter code, EPG grabber sends data back to TVServer after there has been no epg data packets fro 1 minute, so setting a timeout < 1minute will essentially always abort the grab. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Development
Submit: code patches (MediaPortal/TV-Server/etc.)
DVB EPG Grab delay in seconds
Contact us
RSS
Top
Bottom