home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
Installation, configuration support
DVB EPG Grabber runs in endless loop!
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="mm1352000" data-source="post: 1051781" data-attributes="member: 82144"><p>As explained already, it is normal for grabbing to begin with channel 1 again after 4 hours. You probably don't need to grab from 50 (33) channels, so the time could be shortened. In any case, all of this is completely beside the point. I proved with the log file entries that your PC did get to idle state for ~30 minutes. The EPG grabber is not the reason it didn't go into standby. As usual it seems you don't believe me. That's fine. Good luck.</p></blockquote><p></p>
[QUOTE="mm1352000, post: 1051781, member: 82144"] As explained already, it is normal for grabbing to begin with channel 1 again after 4 hours. You probably don't need to grab from 50 (33) channels, so the time could be shortened. In any case, all of this is completely beside the point. I proved with the log file entries that your PC did get to idle state for ~30 minutes. The EPG grabber is not the reason it didn't go into standby. As usual it seems you don't believe me. That's fine. Good luck. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
Installation, configuration support
DVB EPG Grabber runs in endless loop!
Contact us
RSS
Top
Bottom