Reply to thread

Message

<blockquote data-quote="Kotik" data-source="post: 1198344" data-attributes="member: 89825">I dont think the problem is connected to the channels themselfs but rather to a property these channels have, something in the line of from V polarisation to H or something like that, this was actually what i just tested to make sure it is not a switch between satelites during which switch we also change polarisation, apparently it is not since both 1 and 2 are V and i added a channel on 19.2 that is also V and was able to switch to 1 or 2 from it. So it is something else.Regarding the physical aspect i will have to check.I will visit my roof in 5 minutes and try to switch from 1 to 2 and see if the dish is moving to 13.0E.Sent from my GT-I9205 using Tapatalk--- Post updated ---EDIT:Regarding the physical status:In ProgDVB the dish ias always moving to the right position, in MP the dish will move to the right position only the 1st time after that the GoToX position for 13.0E is totally messed and each time u switch to a channel that is on 13.0E MP will send the dish towards 4.8E to be more precise I would say 4.7E.I know it makes no sense but this is exactly what is happening, I then have to store again the position for 13.0E from the diseqc TAB if I want to tune to channel that are on 13.0E.In MP the error will be a PMT error.</blockquote>

[QUOTE="Kotik, post: 1198344, member: 89825"] I dont think the problem is connected to the channels themselfs but rather to a property these channels have, something in the line of from V polarisation to H or something like that, this was actually what i just tested to make sure it is not a switch between satelites during which switch we also change polarisation, apparently it is not since both 1 and 2 are V and i added a channel on 19.2 that is also V and was able to switch to 1 or 2 from it. So it is something else. Regarding the physical aspect i will have to check. I will visit my roof in 5 minutes and try to switch from 1 to 2 and see if the dish is moving to 13.0E. Sent from my GT-I9205 using Tapatalk [SIZE=2][COLOR=rgb(191, 191, 191)]--- Post updated ---[/COLOR][/SIZE] EDIT: Regarding the physical status: In ProgDVB the dish ias always moving to the right position, in MP the dish will move to the right position only the 1st time after that the GoToX position for 13.0E is totally messed and each time u switch to a channel that is on 13.0E MP will send the dish towards 4.8E to be more precise I would say 4.7E. I know it makes no sense but this is exactly what is happening, I then have to store again the position for 13.0E from the diseqc TAB if I want to tune to channel that are on 13.0E. In MP the error will be a PMT error. [/QUOTE]

Verification