Reply to thread

Message

<blockquote data-quote="Teeo" data-source="post: 1025135" data-attributes="member: 98309">Hello!&nbsp;Here is my experience and comments of the card.About 1½ years ago I bought two Mystique satix-s2 sky express dual. Four diseqc 2-1 switches are connected to the cards and two quad lnb´s to feed the switches. The cards work perfectly. Tuning times are between 1600-2500ms.When I came home from vacation, this summer, one of the cards was dead. I ordered a new one to replace it. When I got the new card it was branded as dvbsky and not with a sticker labelled mystique (like on the old card). I contacted support and they said it is the same card and when comparing the new and old card, they look the same, both have s952 printed on them and they work with the same driver (well, almost). There is one difference thou. The old card is v1.0b and the new is v2.0a.My problem is that only tuner lnb input 2,on the new card, works. On lnb input 1 I have &quot;No signal&quot; issues. After fiddling around with lnb input 1 I can determine that it is not broken but have some issues with the diseqc settings (simpleA, simpleB).I read about the heat problems in this thread so I decided to stick some ram heatsinks to the warm parts (this was done after I determined my problems)&nbsp;Is there any way I can assist in getting this hw to work?</blockquote>

[QUOTE="Teeo, post: 1025135, member: 98309"] Hello! Here is my experience and comments of the card. About 1½ years ago I bought two Mystique satix-s2 sky express dual. Four diseqc 2-1 switches are connected to the cards and two quad lnb´s to feed the switches. The cards work perfectly. Tuning times are between 1600-2500ms. When I came home from vacation, this summer, one of the cards was dead. I ordered a new one to replace it. When I got the new card it was branded as dvbsky and not with a sticker labelled mystique (like on the old card). I contacted support and they said it is the same card and when comparing the new and old card, they look the same, both have s952 printed on them and they work with the same driver (well, almost). There is one difference thou. The old card is v1.0b and the new is v2.0a. My problem is that only tuner lnb input 2,on the new card, works. On lnb input 1 I have "No signal" issues. After fiddling around with lnb input 1 I can determine that it is not broken but have some issues with the diseqc settings (simpleA, simpleB). I read about the heat problems in this thread so I decided to stick some ram heatsinks to the warm parts (this was done after I determined my problems) Is there any way I can assist in getting this hw to work? [/QUOTE]

Verification