home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
Electronic Program Guide
"Enter" no longer reliably adds a recording from TV Guide
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="rsbrux" data-source="post: 1283402" data-attributes="member: 49539"><p>While trying to turn on debug log level for MP, I came across an interesting peculiarity. I normally do my maintenance via RDP to an admin account on my HTPC to avoid interfering with the normal interactive use of the 10 ft. GUI. When I make changes to TV Server, some take effect immediately and some require a service restart. If the service is active (e.g. recording) I deny restart and the changes take effect at the next scheduled system reboot. MP client OTOH likes to be restarted after every change. I always deny restart in my RDP session, since that used to try to start MP in my RDP session (I don't know if that is still the case). Instead, I would then restart MP from the 10 ft. GUI or, again, just wait for the scheduled reboot. Up until now, this has worked for everything I have changed in mp Configuration. However, some changes to the General tab (Log verbosity and Watchdog enabled) would not "stick" if I made them while the MP client was running. To get them to take effect, I had to first stop the MP Client, then make the changes in MP Configuration and then restart MP. Curiouser and curiouser!</p></blockquote><p></p>
[QUOTE="rsbrux, post: 1283402, member: 49539"] While trying to turn on debug log level for MP, I came across an interesting peculiarity. I normally do my maintenance via RDP to an admin account on my HTPC to avoid interfering with the normal interactive use of the 10 ft. GUI. When I make changes to TV Server, some take effect immediately and some require a service restart. If the service is active (e.g. recording) I deny restart and the changes take effect at the next scheduled system reboot. MP client OTOH likes to be restarted after every change. I always deny restart in my RDP session, since that used to try to start MP in my RDP session (I don't know if that is still the case). Instead, I would then restart MP from the 10 ft. GUI or, again, just wait for the scheduled reboot. Up until now, this has worked for everything I have changed in mp Configuration. However, some changes to the General tab (Log verbosity and Watchdog enabled) would not "stick" if I made them while the MP client was running. To get them to take effect, I had to first stop the MP Client, then make the changes in MP Configuration and then restart MP. Curiouser and curiouser! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
Electronic Program Guide
"Enter" no longer reliably adds a recording from TV Guide
Contact us
RSS
Top
Bottom