Reply to thread

Message

<blockquote data-quote="Meanman" data-source="post: 58289" data-attributes="member: 21251"><img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite10" alt=":oops:" title="Oops!&nbsp; &nbsp; :oops:" loading="lazy" data-shortname=":oops:" /> Found it and it almost seams to work out just fine.When I selected the device in the Media Portal Setup afterwards, I got the same message as Topher5000; &quot;Unable to create graph for this device!! &quot;Then I selected the cable search and &quot;Tune&quot;. A lot of channels appeared.... so far so good.When I started Media Portal after this I did'nt get any error messages as before, but I still can't see any television picture!When I try to select the &quot;TV on/off&quot; i got a red dot beside the text that disappears at once... no picture.Sounds familiar?_________________Edit:Seems that I was a bit hasty there :? After a restart I was back to the old error message again.&nbsp; Every time I've tried to make a new &quot;tuning&quot; of channels MPO behaves as described above.&nbsp; <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite16" alt=":cry:" title="Crying&nbsp; &nbsp; :cry:" loading="lazy" data-shortname=":cry:" />For your information... I'm using a Hauppauge HVR-1300 card, and the retail application works just fine. No problem watching TV (but the GUI and the functionality of the MPO is a lot better :wink: ).I've som codecs installed; DivX 5.2, FFDshow, XviD and SLD condec pack. Is any of those known to make any problems?</blockquote>

[QUOTE="Meanman, post: 58289, member: 21251"] :oops: Found it and it almost seams to work out just fine. When I selected the device in the Media Portal Setup afterwards, I got the same message as Topher5000; "Unable to create graph for this device!! " Then I selected the cable search and "Tune". A lot of channels appeared.... so far so good. When I started Media Portal after this I did'nt get any error messages as before, but I still can't see any television picture! When I try to select the "TV on/off" i got a red dot beside the text that disappears at once... no picture. Sounds familiar? _________________ Edit: Seems that I was a bit hasty there :? After a restart I was back to the old error message again. Every time I've tried to make a new "tuning" of channels MPO behaves as described above. :cry: For your information... I'm using a Hauppauge HVR-1300 card, and the retail application works just fine. No problem watching TV (but the GUI and the functionality of the MPO is a lot better :wink: ). I've som codecs installed; DivX 5.2, FFDshow, XviD and SLD condec pack. Is any of those known to make any problems? [/QUOTE]

Verification