FireDTV and unable to create graph for this device (1 Viewer)

[ernie]

TV-Server Version:
MediaPortal Version: 0.2.3.0
MediaPortal Skin: BlueTwo
Windows Version: XP Pro + SP2 or SP3
CPU Type: Intel 8200 2.66Mhz
HDD: Seagate 2x120 G
Memory: 2x CM2X1024-6400
Motherboard: Corsair
Video Card: Intel Chipst G35
Video Card Driver: Intel 6.14.10.4935
Sound Card: Realtek ALC889A
Sound Card AC3: optical out
Sound Card Driver: 510.0.5404
1. TV Card: FireDTV S2
1. TV Card Type: DVB-S
1. TV Card Driver: 4.5N
2. TV Card:
2. TV Card Type:
2. TV Card Driver:
3. TV Card:
3. TV Card Type:
3. TV Card Driver:
4. TV Card:
4. TV Card Type:
4. TV Card Driver:
MPEG2 Video Codec: MPV Decoder Filter
MPEG2 Audio Codec: MPA Decoder Filter
h.264 Video Codec: none
Satelite/CableTV Provider: Astra19.2E
HTPC Case: OrigenAe
Cooling: Zalman8700
Power Supply: Hiper 480watts
Remote: MCE
TV: Sony PFM
TV - HTPC Connection: DVI



From a very clean install (Starting from disk format) + MP 02.3.0 ( standard install) I can't add this FireDTV card with the configuration.exe tool

I test with XP+SP2 or with XP+ SP3, each of then with or without the last SVN and I get back always the same message: unable to create graph for this devise

My config was update, the log joined. Do you need some more infos?

Many thanks for the support, some explanations, a fix !!

 

[chemelli]

Please try updating to 1.0.0 RC1 from MEDIAPORTAL - free MediaCenter HTPC Software - MediaPortal Downloads.

Simone

 

[ernie]

Many thanks for the very quick feed back.

I install SQL, MP server, MP client, I succeed to config all this stuff, to scan Astra, and run the client but......

the system crash after 2 or 3 minutes. If I restart MP (even after a boot) the Cam does'nt work any more.
I will be back to morrow with the the log and more details.

Bye

 

[iosub]

What cam are you using? also tell me the firedtv firm that you are using.., there is a tool at digital everywhere - FireDTV Support Tool

Iosu

 

[ernie]

next step; next stop!

I use PowerCam - cas: Viacess,
firmware 071116_firedtv_firmware or 080415_firedtv_firmware (I tested the two)

The board works with the every-where software 071130-FireDTV-Setup-4-5-N

Bye Ernie

 

[Al_Capone]

Is there a solution for 2.3.x ?
Same problem here..

 

[kgk]

Same problem with 0.2.3 here.

0.2.3 = unable to create graph
1.0.0 RC1 = crash ( blue screen + reboot ) while scanning for channels.
I am not using a cam - FireDTV S2 using latest firmware and latest drivers

 

[Al_Capone]

after installing recommended patches, I am using 1.0.0RC1 +SVN just fine, - I had no problems with (OS) crashes anymore.
I also installed latest Windows Media Player (bloatware) - I do not know if it helped, but I did.