home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
Installation, configuration support
firedtv remote wakeup
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="kszabo" data-source="post: 303850" data-attributes="member: 61646"><p>I had same problem: Antec Fusion goes into standby with remote but does not wake up with remote.</p><p></p><p><strong>The problem was:</strong></p><p>You have to change the cabling of the case! You have to remove the front part, connect the power connector with white-black wires (coming from power button) with the display on the opposite side (it has a two-pin connector with PWR and GRND). Connect the colour-wired (purple-black) power connector coming from display with the motherboard! Antec states that this is the standard config but I have seen 2 Antec Fusion cases till now and both of them were not so configured (the black-white power cable was not connected to the display)</p><p></p><p>Plus:</p><p>BIOS: enable S3 hibernate and wakeup allowed from USB device (I guess not necessary)</p><p>configure power management in iMon software (what should happen on power button from remote)</p><p>display must have power if PC shut down, there is a 3pin power cable, don´t forget to connect it</p></blockquote><p></p>
[QUOTE="kszabo, post: 303850, member: 61646"] I had same problem: Antec Fusion goes into standby with remote but does not wake up with remote. [B]The problem was:[/B] You have to change the cabling of the case! You have to remove the front part, connect the power connector with white-black wires (coming from power button) with the display on the opposite side (it has a two-pin connector with PWR and GRND). Connect the colour-wired (purple-black) power connector coming from display with the motherboard! Antec states that this is the standard config but I have seen 2 Antec Fusion cases till now and both of them were not so configured (the black-white power cable was not connected to the display) Plus: BIOS: enable S3 hibernate and wakeup allowed from USB device (I guess not necessary) configure power management in iMon software (what should happen on power button from remote) display must have power if PC shut down, there is a 3pin power cable, don´t forget to connect it [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
Installation, configuration support
firedtv remote wakeup
Contact us
RSS
Top
Bottom
