Going to standby with singleseat, q's (1 Viewer)

[datfreak]

Sorry if this has been done in another thread but..

Using powerscheduler in MP, i also saw a powerscheduler tv server plugin under main mp.
There is also powerscheduler in the tv server-

So there are 3 different plugins with each own have its own settings??

I also noticed the standby button on the remote dosnt work with the new rc1 install, SO is standby achieved by idle time on the mainscreen?
If it is how would I set it up to -say- go to standby after 10 minutes of idle time?
Do i need to put info into each of the 3 plugins?

thanks for your help

 

[Paranoid Delusion]

TV-Server/Configuration/Plugins/PowerScheduler - MediaPortal Wiki Documentation

I also noticed the standby button on the remote dosnt work with the new rc1 install,

MCE remote works fine here.

 

[datfreak]

so when singleseated...

I need to config the powerscheduler in TV SERVER and the powerscheduler plug-in for tvserver in MP??

Do I config both with the same settings?

And to verify, I have to disable the old original MP powerscheduler plugin, right?

My system isnt going into standby(but it used to with the non-tv server setup)-- so I want to work out why.

thanks

 

[Paranoid Delusion]

Do I config both with the same settings?

Recommended.

And to verify, I have to disable the old original MP powerscheduler plugin, right?

Correct.

if testing forget the MP bit, just try it with TVServer running as service, mines set to standby after 10 mins, which it does successfully.