Reply to thread

Message

<blockquote data-quote="WileECoyote" data-source="post: 736813" data-attributes="member: 83474">Hey Andy,A lot depends on the splitter installed. Do you have individual codec's installed or did you install SAF (or somthing similar)? The splitter determines which codec best fits the video/audio stream. The HD-PVR pumps out H264 video, so the splitter detects it and chooses the best (or highest priority) codec and plays the video.I have an ATI 5550 video card, so I used BMan's instructions here to set up my system (Specifically the ATI5000.pdf file) -&gt; <a href="https://forum.team-mediaportal.com/644654-post14.html" target="_blank">https://forum.team-mediaportal.com/644654-post14.html</a>I have used that same procedure on ALL my machines (including the clients I dont bitstream) and it works perfectly. The only thing I do in addition to his instructions is set the MPEG 2 priority to FFDSHOW.Only installing those few codecs should be all you need to run almost any video/audio combination. NOTE: Arcsoft TME installs its own codecs and splitter that has a higher priority than those outlined in BMans procedure above. This caused me all kinds of issues, so I ended up uninstalling the TME software all together.Im at work right now, but if you like I can attach some screenshots of my configuration when I get home...Wile E.</blockquote>

[QUOTE="WileECoyote, post: 736813, member: 83474"] Hey Andy, A lot depends on the splitter installed. Do you have individual codec's installed or did you install SAF (or somthing similar)? The splitter determines which codec best fits the video/audio stream. The HD-PVR pumps out H264 video, so the splitter detects it and chooses the best (or highest priority) codec and plays the video. I have an ATI 5550 video card, so I used BMan's instructions here to set up my system (Specifically the ATI5000.pdf file) -> [url]https://forum.team-mediaportal.com/644654-post14.html[/url] I have used that same procedure on ALL my machines (including the clients I dont bitstream) and it works perfectly. The only thing I do in addition to his instructions is set the MPEG 2 priority to FFDSHOW. Only installing those few codecs should be all you need to run almost any video/audio combination. [B][COLOR="Red"]NOTE[/COLOR][/B]: Arcsoft TME installs its own codecs and splitter that has a higher priority than those outlined in BMans procedure above. This caused me all kinds of issues, so I ended up uninstalling the TME software all together. Im at work right now, but if you like I can attach some screenshots of my configuration when I get home... Wile E. [/QUOTE]

Verification