Reply to thread

Message

<blockquote data-quote="tenuhseegeek" data-source="post: 744374" data-attributes="member: 112966">Ok, I did not set up the software for this, just the IR drivers. I did install WinTV that came on the CD and tested and I DO get audio. I will look into installing the Arcsoft (if it is on the disk) I hadn't noticed that. Will report back what I find.This is what trows me off, the blaster part works, flawlessly... I can change channels (via keyboard) and it will change the channel on my Dish Network 7000 series receiver. It's the IR from the remote to navigate menus in Mediaportal. I am used to Linux and this is pretty new to me so I don't know where logs would be stored for the IR part. I used to use a utility &quot;irw&quot; on Linux to see the actual remote sending/receiving commands. No such tool here for testing...is there?I will try what you suggested tonight and get back some details to you. I know this thread is for development on 1.2beta, but isn't this &quot;kinda&quot; helping development?</blockquote>

[QUOTE="tenuhseegeek, post: 744374, member: 112966"] Ok, I did not set up the software for this, just the IR drivers. I did install WinTV that came on the CD and tested and I DO get audio. I will look into installing the Arcsoft (if it is on the disk) I hadn't noticed that. Will report back what I find. This is what trows me off, the blaster part works, flawlessly... I can change channels (via keyboard) and it will change the channel on my Dish Network 7000 series receiver. It's the IR from the remote to navigate menus in Mediaportal. I am used to Linux and this is pretty new to me so I don't know where logs would be stored for the IR part. I used to use a utility "irw" on Linux to see the actual remote sending/receiving commands. No such tool here for testing...is there? I will try what you suggested tonight and get back some details to you. I know this thread is for development on 1.2beta, but isn't this "kinda" helping development? [/QUOTE]

Verification