Reply to thread

Message

<blockquote data-quote="PsyVision" data-source="post: 817849" data-attributes="member: 113790">Hi,I am trying to get my Colossus set up and I am having a few issues so wouldn't find if someone could lend a hand please.&nbsp; My set up is the HDMI output of a Virgin Media (UK) set top box into a HDFury3 to remove HDCP.&nbsp; The component output of this is then into the Colossus.&nbsp; I am able to receive video and sound fine however I am having an issue with the IR blasting.I have installed the Hauppauge IR software along with IRSS.&nbsp; Now here is where I fall down, I can't find the IR codes/setup (within the Hauppauge application) for the box anywhere and so I presume I am one of the few doing this with a Cisco Virgin Media box.&nbsp; Is there a way I can figure it out how it should be setup?&nbsp; I notice that you can 'learn' commands with the Hauppauge app although it wouldn't recognise input from my Virgin remote at all it seems.&nbsp; I don't know if I need IRSS but I have configured it to receive Hauppauge input although there is no transmit check box.Another question to ask is, once I have the IR blaster configured, how do I configure MediaPortal to change the channel for me?&nbsp; At the moment I have the standard channels (CVBS, S-Video, YRYBY, HDMI) whereas I would prefer individual channels (BBC1, 2, ITV etc..)I see you guys were discussing the tabs in the TV-Server Setup for the card, my Settings tab controls are enabled, some of the VideoProcAmp controls are, and my encoder doesn't support quality checking.&nbsp; Out of interest, what encoder are people using for the Colossus?I am using MP 1.2.1 and I don't think I have installed the WMC plugin as I don't use WMC at all (although I did install WinTV).Thanks in advance.</blockquote>

[QUOTE="PsyVision, post: 817849, member: 113790"] Hi, I am trying to get my Colossus set up and I am having a few issues so wouldn't find if someone could lend a hand please. My set up is the HDMI output of a Virgin Media (UK) set top box into a HDFury3 to remove HDCP. The component output of this is then into the Colossus. I am able to receive video and sound fine however I am having an issue with the IR blasting. I have installed the Hauppauge IR software along with IRSS. Now here is where I fall down, I can't find the IR codes/setup (within the Hauppauge application) for the box anywhere and so I presume I am one of the few doing this with a Cisco Virgin Media box. Is there a way I can figure it out how it should be setup? I notice that you can 'learn' commands with the Hauppauge app although it wouldn't recognise input from my Virgin remote at all it seems. I don't know if I need IRSS but I have configured it to receive Hauppauge input although there is no transmit check box. Another question to ask is, once I have the IR blaster configured, how do I configure MediaPortal to change the channel for me? At the moment I have the standard channels (CVBS, S-Video, YRYBY, HDMI) whereas I would prefer individual channels (BBC1, 2, ITV etc..) I see you guys were discussing the tabs in the TV-Server Setup for the card, my Settings tab controls are enabled, some of the VideoProcAmp controls are, and my encoder doesn't support quality checking. Out of interest, what encoder are people using for the Colossus? I am using MP 1.2.1 and I don't think I have installed the WMC plugin as I don't use WMC at all (although I did install WinTV). Thanks in advance. [/QUOTE]

Verification