Reply to thread

Message

<blockquote data-quote="sbp" data-source="post: 249308" data-attributes="member: 23951">Hi AaronThanks for the IR-Server Suit you mailed me. I have the stable version 0.2.3.0 (no SVN) - and have been using the build-in support for the Hauppauge remote and blaster - and all was working, though not 100% correct channel change every time....I then wanted to try the IR Server Suite. But I can't get it to work at&nbsp; all. I can't even use the remote to control MP, it is not reacting to button press on the remote.Here are the steps I followed:1. In Mediaportal config in the remote section, I removed the check-mark on &quot;Use Hauppauge remote&quot;2. In Mediaportal plugin I removed the check-mark on Hauppauge IR-Blaster - so it aint enebled anymore.3. I made sure that your plugin &quot;MP Control Plugin for IR-server&quot; was enabled.4. I started&nbsp; &quot;Input service configuration&quot; and here I enabled Hauppauge remote.But it won't let me control anything. I even started &quot;Translator&quot; and tried to make a new button mapping, and then pressed a button on the remote - but it timed out.Have I missed something obivious - that I should have enabled?RegardsSteen</blockquote>

[QUOTE="sbp, post: 249308, member: 23951"] Hi Aaron Thanks for the IR-Server Suit you mailed me. I have the stable version 0.2.3.0 (no SVN) - and have been using the build-in support for the Hauppauge remote and blaster - and all was working, though not 100% correct channel change every time.... I then wanted to try the IR Server Suite. But I can't get it to work at all. I can't even use the remote to control MP, it is not reacting to button press on the remote. Here are the steps I followed: 1. In Mediaportal config in the remote section, I removed the check-mark on "Use Hauppauge remote" 2. In Mediaportal plugin I removed the check-mark on Hauppauge IR-Blaster - so it aint enebled anymore. 3. I made sure that your plugin "MP Control Plugin for IR-server" was enabled. 4. I started "Input service configuration" and here I enabled Hauppauge remote. But it won't let me control anything. I even started "Translator" and tried to make a new button mapping, and then pressed a button on the remote - but it timed out. Have I missed something obivious - that I should have enabled? Regards Steen [/QUOTE]

Verification