How to select TV card on TV3. (1 Viewer)

[rebreather]

First of all a big thank the development team for a great software. I just got the latest TV3 and SVN (16362) installed and its runs great.

I just have a problem with my TV cards, one Floppy DTV and a Hauppauge Analog PVR500, on MP I use to watch live with the digital card and use the 2 analog tuners for recording. As far I can see I don’t have these options on TV3 and it just chose the card randomly.

I was asking this question in another thread https://forum.team-mediaportal.com/tv_server_problems-t30016.html?t=30016 were Marcus was helping me

I hope there is a way to get around this as my tv picture is much better on the digital card and i prefer to have it running like this.

Best regards

Lars

 

[walkerx]

as long as the card uses BDA drivers then should pick up without problems, especially if worked when just running media-portal. I know when i setup tv engine it automatically detected my card (HVR-1300) and setup both analog and digital without problems, and done it better than media-prortal by itself

 

[Paranoid Delusion]

tv picture is much better on the digital card

Time to save up for another DVB card i think, i hate viewing analogue.

 

[rebreather]

Yes it would be the easy way to get another tuner card but then i will also have the problem get another Selector card from my operator to be able to watch the coded chanals.

I think all the time i been using MP before the TV server i was great to have the options to select tuner card so the few shows i recorded was on the analog card, but all my live tv was digital.

I changed to the TV engine so i had the suptitles wish i didnt had without the TV engine, so is a æittle give and take as i only use it as a single seat setup.

Is there any plans in the future to get the card selection options back ?


Regards

Lars