Reply to thread

Message

<blockquote data-quote="Mew" data-source="post: 421866" data-attributes="member: 29012">HiLooking at the picture, I think your setup for hybrid groups is not quite right. You have set up 2 hybrid groups (S and F) with part of the HVR-4000 card in each. This means TV Server thinks these are two physically separate tuners that can be used independently which is not the case with the HVR-4000, you can either use DVB-S/S2, DVB-T or analogue. You need to define one hybrid group and add both the DVB-S/S2 and DVB-T tuner in. This tells TV server only one of these tuners is available at a time.I have 2 HVR-4000s working in TV Server (but only one has both DVB-S/S2 and DVB-T enabled, the other just has DVB-S/S2). I have defined 2 hybrid groups, one for each physical card. I did have an issue working out which tuners belonged to which card as there were 2 DVB-T and 2 DVB-S/S2 tuners named the same in TV Server. I had to disconnect the leads from the card and try a channel scan to determine which was which. I believe this hybrid setup is working but it is a little difficult to tell as switching from DVB-T to DVB-S could be switching to the the other physical card.I hope this helpsMew</blockquote>

[QUOTE="Mew, post: 421866, member: 29012"] Hi Looking at the picture, I think your setup for hybrid groups is not quite right. You have set up 2 hybrid groups (S and F) with part of the HVR-4000 card in each. This means TV Server thinks these are two physically separate tuners that can be used independently which is not the case with the HVR-4000, you can either use DVB-S/S2, DVB-T or analogue. You need to define one hybrid group and add both the DVB-S/S2 and DVB-T tuner in. This tells TV server only one of these tuners is available at a time. I have 2 HVR-4000s working in TV Server (but only one has both DVB-S/S2 and DVB-T enabled, the other just has DVB-S/S2). I have defined 2 hybrid groups, one for each physical card. I did have an issue working out which tuners belonged to which card as there were 2 DVB-T and 2 DVB-S/S2 tuners named the same in TV Server. I had to disconnect the leads from the card and try a channel scan to determine which was which. I believe this hybrid setup is working but it is a little difficult to tell as switching from DVB-T to DVB-S could be switching to the the other physical card. I hope this helps Mew [/QUOTE]

Verification