iMON + Remote + Power on.. How? (1 Viewer)

[jabalsad]

Hi,

Not sure if anyone here will be able to help, its about the closest community i know

I have a Antec case with terrible support for its IR receiver. Combined with iMON it works fine, however I have one question: How do I get to power my PC on using my MCE remote? I managed fine getting it to go into sleep mode when i press the power button, but then no way to get it to go back on. Any ideas will be welcome!

Thanks

 

[JackTramiel]

As far is I know the mce remote can learn from other remotes. If it does it by holding the original remote against the mce remote then it should work fine if you press the power button. You might have done it this way, just a thought.
If it is not working with the imon remote either you might need to change a jumper on your mainboard for usb power on if the pc is shut down.

 

[jabalsad]

Well I dont have a imon remote, i'm just using the imon software because there isnt anything better

With my zalman case it was simply a thing i had to program to the remote... But the antec case doesnt have great support for these kinds of things.

I really hope it doesnt come to setting jumpers on the mobo, i'm sure there is a simpler way? If not, i dont mind doing it that way then i suppose..

 

[JackTramiel]

What would be simpler then switching a jumper? Just have a look at the manual if you can change the usb power settings this way.