Reply to thread

Message

<blockquote data-quote="Olli0815" data-source="post: 242762" data-attributes="member: 24297">Hi Aaron,thanks for the quick replay.I did reset my MCE. The standard behavior of the TV Power - is exit MP and it works.I can map the new command. But nothing happens....Hmm, maybe there is a misunderstanding:what is the right approach to let the MCE Remote send the new learned IR command to control the foreign device via MCE- just map the command to the Button in the config ??? That doesn't work here.Regards,OlliOk, I got it ! It only works, if you use the additional MCE IR sender...and place / stick them in front of the forgein decive, in my case - on the TV...as the MCE transreciever is placed below the TV there is no other change to send the command -this make sense.Hmm, but that is what i was afraid of...is there no chance to reset the commands straight on the MCE remote (sender)- I don't want to paste up my whole equipment with this senders?regards,Olli</blockquote>

[QUOTE="Olli0815, post: 242762, member: 24297"] Hi Aaron, thanks for the quick replay. I did reset my MCE. The standard behavior of the TV Power - is exit MP and it works. I can map the new command. But nothing happens.... Hmm, maybe there is a misunderstanding: what is the right approach to let the MCE Remote send the new learned IR command to control the foreign device via MCE- just map the command to the Button in the config ??? That doesn't work here. Regards, Olli Ok, I got it ! It only works, if you use the additional MCE IR sender...and place / stick them in front of the forgein decive, in my case - on the TV...as the MCE transreciever is placed below the TV there is no other change to send the command -this make sense. Hmm, but that is what i was afraid of...is there no chance to reset the commands straight on the MCE remote (sender)- I don't want to paste up my whole equipment with this senders? regards, Olli [/QUOTE]

Verification