Reply to thread

Message

<blockquote data-quote="alexdepalma" data-source="post: 1231925" data-attributes="member: 66361">Hi Guys!I have been checking the Auto 3D mod version and so far its working good in SBS and TAB. Subtitles are ok only if then new menu option is Active. I see the videos actually in 3D. No conversion to 3D. Subtitles ok, but stick to the screen. They have O (ZERO) distance from the screen. In my opinion this option should be normally active on 3D modes as without it, subtitles only come to one eye. So even with distance 10 pixels, they are flat.One important thing is, I use 4K resolutions only. With Frame packet 3D, my projector needs to come back to 1080P or no change possible (I think is the standard) even with TAB or SBS 3D. Frame packet 3D since last MadVr MediaPortal versions, is automatically done but not with SBS or TAB. Is it possible ([USER=60104]@Sebastiii[/USER] ) to make this magic on Auto3D?I have one 3D film (Ghost in Shell) TAB that 3D sync is not working, Let me explain. The Video is not fully split by half. Some black lines at the bottom and the top. Only very few. This creates some lines belonging to the lower part of the upper frame to appear on the top of the lower frame (TAB video).. Son when going to 3D the image of the right eye is slightly lower than the other eye and video is not right. As far as I remember with previous versions of Auto3D there was no problem. May be the video is not prperly procesed&nbsp;RegardsA</blockquote>

[QUOTE="alexdepalma, post: 1231925, member: 66361"] Hi Guys! I have been checking the Auto 3D mod version and so far its working good in SBS and TAB. Subtitles are ok only if then new menu option is Active. I see the videos actually in 3D. No conversion to 3D. Subtitles ok, but stick to the screen. They have O (ZERO) distance from the screen. In my opinion this option should be normally active on 3D modes as without it, subtitles only come to one eye. So even with distance 10 pixels, they are flat. One important thing is, I use 4K resolutions only. With Frame packet 3D, my projector needs to come back to 1080P or no change possible (I think is the standard) even with TAB or SBS 3D. Frame packet 3D since last MadVr MediaPortal versions, is automatically done but not with SBS or TAB. Is it possible ([USER=60104]@Sebastiii[/USER] ) to make this magic on Auto3D? I have one 3D film (Ghost in Shell) TAB that 3D sync is not working, Let me explain. The Video is not fully split by half. Some black lines at the bottom and the top. Only very few. This creates some lines belonging to the lower part of the upper frame to appear on the top of the lower frame (TAB video).. Son when going to 3D the image of the right eye is slightly lower than the other eye and video is not right. As far as I remember with previous versions of Auto3D there was no problem. May be the video is not prperly procesed Regards A [/QUOTE]

Verification