I'm currently using IR Server Suite 1.4.2 RC1, Microsoft MCE Remote/Blaster and Windows Vista.
I've set up Translator so that when the 'PC_Resume' event occurs it will run a macro which sends IR signals to turn on my amplifier, set the correct input etc. While the macro works fine if I run it manually, IR Server Suite fails to sent the IR signals after hibernation, however it does send them after resuming from standby. In fact after hibernation IR Server Suite will usually fail to send any IR until I restart its service.
I've attached the logs below which shows that I manually sent some IR signals from Translator, then hibernated and resumed the computer and then you can see that the following IR blast attempts fail due to a "Device not available" problem.
Thanks for any help,
Grant
I've set up Translator so that when the 'PC_Resume' event occurs it will run a macro which sends IR signals to turn on my amplifier, set the correct input etc. While the macro works fine if I run it manually, IR Server Suite fails to sent the IR signals after hibernation, however it does send them after resuming from standby. In fact after hibernation IR Server Suite will usually fail to send any IR until I restart its service.
I've attached the logs below which shows that I manually sent some IR signals from Translator, then hibernated and resumed the computer and then you can see that the following IR blast attempts fail due to a "Device not available" problem.
Thanks for any help,
Grant