home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
Installation, configuration support
mediaportal and dolby dts /5.1
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="gilberti69" data-source="post: 329315" data-attributes="member: 75332"><p>I had lots of fun setting up my amp via SPDIF too then eventually found the output was disabled in a setting in the mixer.</p><p></p><p>The shots you posted look like you've found all those though, but don't forget the 'MUTE' on the taskbar!</p><p></p><p>One thing you can check is you should be able to see light at the end of the SPDIF cable if you unplug it from the amp (hold your hand in front of the cable DON'T LOOK DOWN IT!!)</p><p></p><p>If you see light (on mine it's red) then the amp is either not recognising the signal or there is a problem on the amp side.</p><p></p><p>If you can see light from the PC card but not the other end of the cable then the cable is faulty, they are easily broken.</p><p></p><p>Also make sure you are using the correct connector on the card if there is more than one.</p><p></p><p>hope this helps</p></blockquote><p></p>
[QUOTE="gilberti69, post: 329315, member: 75332"] I had lots of fun setting up my amp via SPDIF too then eventually found the output was disabled in a setting in the mixer. The shots you posted look like you've found all those though, but don't forget the 'MUTE' on the taskbar! One thing you can check is you should be able to see light at the end of the SPDIF cable if you unplug it from the amp (hold your hand in front of the cable DON'T LOOK DOWN IT!!) If you see light (on mine it's red) then the amp is either not recognising the signal or there is a problem on the amp side. If you can see light from the PC card but not the other end of the cable then the cable is faulty, they are easily broken. Also make sure you are using the correct connector on the card if there is more than one. hope this helps [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
Installation, configuration support
mediaportal and dolby dts /5.1
Contact us
RSS
Top
Bottom
