home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
General Support
Mediaportal Freeview HD New Zealand not working
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="scullen" data-source="post: 520252" data-attributes="member: 81954"><p>Thanks for the further replies guys.</p><p>Kiwijunglist I have 3GB of memory installed so surely that is heaps is it not??</p><p>Anyway I followed your instructions and made the following changes. As far as my TV reception goes it is perfect. Using the same aerial with a normal TV gives near perfect pictures. The pictures I get with Freeview HD on MP are crisps too but like I say they just start lagging and going out of sync after less than a minute.</p><p>I have installed new grapichs drivers and done the foloowing;</p><p>OK i downloaded the HD Pack 2.2 and installed it then changed the h.264 codec in MP Config to the latest Cyberlink V9 codec. Selected EVR and that seemed to make it much worse. It froze up completely instantly. I then took the tick off the hardware acceleration under the Direct Show/ PowerDVD Section of the MP config and that worked for about 2 minutes then it started to jump everywhere again.</p><p>When I used shift+! for about 5 minutes these are the results</p><p>EVR - 5.99 - 3.39 </p><p>AVG FPS - 29-33</p><p>DRAWN - 20925</p><p>DROPPED - 790</p><p>JITTER - -6 to 60</p><p></p><p>All of these parameters were flucuating continually over the 5 minute period.</p><p>I downloaded and ran graphstudio but could not get it to work with MP.</p></blockquote><p></p>
[QUOTE="scullen, post: 520252, member: 81954"] Thanks for the further replies guys. Kiwijunglist I have 3GB of memory installed so surely that is heaps is it not?? Anyway I followed your instructions and made the following changes. As far as my TV reception goes it is perfect. Using the same aerial with a normal TV gives near perfect pictures. The pictures I get with Freeview HD on MP are crisps too but like I say they just start lagging and going out of sync after less than a minute. I have installed new grapichs drivers and done the foloowing; OK i downloaded the HD Pack 2.2 and installed it then changed the h.264 codec in MP Config to the latest Cyberlink V9 codec. Selected EVR and that seemed to make it much worse. It froze up completely instantly. I then took the tick off the hardware acceleration under the Direct Show/ PowerDVD Section of the MP config and that worked for about 2 minutes then it started to jump everywhere again. When I used shift+! for about 5 minutes these are the results EVR - 5.99 - 3.39 AVG FPS - 29-33 DRAWN - 20925 DROPPED - 790 JITTER - -6 to 60 All of these parameters were flucuating continually over the 5 minute period. I downloaded and ran graphstudio but could not get it to work with MP. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
General Support
Mediaportal Freeview HD New Zealand not working
Contact us
RSS
Top
Bottom