Normal
I've soldered the Kycon connector to the cable. It was not so easy, but doable thanks to pdf file from Kycon website. I just connected the wires to the pins like they're layout in the cable. Not like they're supposed to be normally: 2x 12v one side, 2x ground other side. The powersupply automatically switches on now, because I soldered the signal wires to the shielding inside the connector.At the moment I'm preparing a piece of the black mesh to be sawed in a fitting shape. I've put it between 2 pieces of mdf. On the top mdf plate I've made a drawing of the top metal plate of the AOpen case with the fan hole and a hexagon shape covering it which is going to be sawed out. I'm going to bolt it all together, so nothing can move while sawing.
I've soldered the Kycon connector to the cable. It was not so easy, but doable thanks to pdf file from Kycon website. I just connected the wires to the pins like they're layout in the cable. Not like they're supposed to be normally: 2x 12v one side, 2x ground other side. The powersupply automatically switches on now, because I soldered the signal wires to the shielding inside the connector.
At the moment I'm preparing a piece of the black mesh to be sawed in a fitting shape. I've put it between 2 pieces of mdf. On the top mdf plate I've made a drawing of the top metal plate of the AOpen case with the fan hole and a hexagon shape covering it which is going to be sawed out. I'm going to bolt it all together, so nothing can move while sawing.
