Reply to thread

Message

<blockquote data-quote="swamprat96" data-source="post: 660357" data-attributes="member: 105223">Well I bit the bullet and replaced the hauppage Nova T-500 with a Hauppage HVR-2210 - because the POS Nova locked up on resume often. Known issue I know but I decided it was going to condemn is WAF factor so out it went.As a result I had to completely uninstall MP and do a fresh install. The power problem &quot;seems&quot; to be fixed- time will tellSpoke too soon. Back to its old behaviour. For some reason the Powertoggle command is not sent by the Watch Tv activity- even though the software has been configured to power on the media center. This only affects the HTPC when MP power scheduler has put it into suspend. If I use the remote to power down it always comes back OKSo for now I've set Power scheduler only to wake up for events. Thats only recording anyway which we don't do much and we can shut it down manuallyAny proper solution welcome</blockquote>

[QUOTE="swamprat96, post: 660357, member: 105223"] Well I bit the bullet and replaced the hauppage Nova T-500 with a Hauppage HVR-2210 - because the POS Nova locked up on resume often. Known issue I know but I decided it was going to condemn is WAF factor so out it went. As a result I had to completely uninstall MP and do a fresh install. The power problem "seems" to be fixed- time will tell Spoke too soon. Back to its old behaviour. For some reason the Powertoggle command is not sent by the Watch Tv activity- even though the software has been configured to power on the media center. This only affects the HTPC when MP power scheduler has put it into suspend. If I use the remote to power down it always comes back OK So for now I've set Power scheduler only to wake up for events. Thats only recording anyway which we don't do much and we can shut it down manually Any proper solution welcome [/QUOTE]

Verification