home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
MediaPortal 1 Talk
motorised dish setup advice / help
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Kotik" data-source="post: 1198455" data-attributes="member: 89825"><p>It is the same issue i was getting with a SkyStar HD2 card.</p><p>There is no solution regarding this one, increasing the "Tune" time out wont change anything besides forcing you to wait more time before the No Signal message pops out.</p><p></p><p>MediaPortal DiseqC code is poorly optimized for a motor support, at least for the 2 cards that i had the possibility to try out, SkyStar HD2 and TBS 6902.</p><p></p><p>I am currently in contact with TBS to see if anything can be done from their side but i doubt it cause MediaPortal is always instructing a card to tune/lock into a signal directly after sending the gotoX command, like [USER=82144]@mm1352000[/USER] says there are no delays implemented between the gotox and tune commands.</p></blockquote><p></p>
[QUOTE="Kotik, post: 1198455, member: 89825"] It is the same issue i was getting with a SkyStar HD2 card. There is no solution regarding this one, increasing the "Tune" time out wont change anything besides forcing you to wait more time before the No Signal message pops out. MediaPortal DiseqC code is poorly optimized for a motor support, at least for the 2 cards that i had the possibility to try out, SkyStar HD2 and TBS 6902. I am currently in contact with TBS to see if anything can be done from their side but i doubt it cause MediaPortal is always instructing a card to tune/lock into a signal directly after sending the gotoX command, like [USER=82144]@mm1352000[/USER] says there are no delays implemented between the gotox and tune commands. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
MediaPortal 1 Talk
motorised dish setup advice / help
Contact us
RSS
Top
Bottom