Reply to thread

Message

<blockquote data-quote="RonD" data-source="post: 1221181" data-attributes="member: 117536">updated wording to say &quot;stream ID&quot;.Will look into getting wireshark setup, BUT not obvious how to reproduce this problem on-demand. I thought the key to reproduce was close MP Client, open MP Client, wait a few minutes for TV-Series etc to finish all startup, scanning, etc. Then watch RecordedTV, see 1st fail then work. I tried to reproduce 2 or 3 times later and problem did not show up again. What was weird, the problem 1st happened at 10:32 when I 1st noticed problem, then again at 10:45 with the Client Log files I uploaded.I've seen this on 2 or 3 different days since upgrade to MP1.16, never saw this problem with MP1.12, all on same TV-Server, MP-Client systems, and network setup.This Client (L3521) is wired 1 Gbps Ethernet through 2 ethernet switches to TV Server, all 1 Gbps Ethernet. I've also seen this problem on 2nd MP-Client that uses 5 GHz Wifi to ethernet switch to TV Server. This is all after closing MP Client, start MP Client, going to RecordedTV, so MP Client and Server have sent a fair amount of network traffic, strange that &quot;open&quot; fails after all that traffic, video streaming then a 2nd &quot;open&quot; fails.</blockquote>

[QUOTE="RonD, post: 1221181, member: 117536"] updated wording to say "stream ID". Will look into getting wireshark setup, BUT not obvious how to reproduce this problem on-demand. I thought the key to reproduce was close MP Client, open MP Client, wait a few minutes for TV-Series etc to finish all startup, scanning, etc. Then watch RecordedTV, see 1st fail then work. I tried to reproduce 2 or 3 times later and problem did not show up again. What was weird, the problem 1st happened at 10:32 when I 1st noticed problem, then again at 10:45 with the Client Log files I uploaded. I've seen this on 2 or 3 different days since upgrade to MP1.16, never saw this problem with MP1.12, all on same TV-Server, MP-Client systems, and network setup. This Client (L3521) is wired 1 Gbps Ethernet through 2 ethernet switches to TV Server, all 1 Gbps Ethernet. I've also seen this problem on 2nd MP-Client that uses 5 GHz Wifi to ethernet switch to TV Server. This is all after closing MP Client, start MP Client, going to RecordedTV, so MP Client and Server have sent a fair amount of network traffic, strange that "open" fails after all that traffic, video streaming then a 2nd "open" fails. [/QUOTE]

Verification