Reply to thread

Message

<blockquote data-quote="Tropics" data-source="post: 411338" data-attributes="member: 90633">Hi, just a note which setup works here. I have an AverMedia A188 card, which did usually work after Standby but does not when MediaPortal was playing Music before hitting the Standby button. Funny, but that's how it was. The following setup also works reliably in that scenario:Standby: Stop MediaPortal (Kill Immediately)Resume: a) Stop TV Service (Kill Immediately)b) Reset Hardware (TV Card)c) Start TV Service (no detection delay needed)d) Start MediaPortalThanks for all the hints in this thread, especially the note that you can't kill the tv service when going into standby if you want scheduled recordings to wake up your pc, so that has to be done right after resuming.Final thoughts: I think this piece of quality software deserves an installer. Also I don't get it why the service is not started from the batch file as you will most likely need it right away. Same with the userspace executable.</blockquote>

[QUOTE="Tropics, post: 411338, member: 90633"] Hi, just a note which setup works here. I have an AverMedia A188 card, which did usually work after Standby but does not when MediaPortal was playing Music before hitting the Standby button. Funny, but that's how it was. The following setup also works reliably in that scenario: Standby: Stop MediaPortal (Kill Immediately) Resume: a) Stop TV Service (Kill Immediately) b) Reset Hardware (TV Card) c) Start TV Service (no detection delay needed) d) Start MediaPortal Thanks for all the hints in this thread, especially the note that you can't kill the tv service when going into standby if you want scheduled recordings to wake up your pc, so that has to be done right after resuming. Final thoughts: I think this piece of quality software deserves an installer. Also I don't get it why the service is not started from the batch file as you will most likely need it right away. Same with the userspace executable. [/QUOTE]

Verification