Reply to thread

Message

<blockquote data-quote="Das Hammer" data-source="post: 157110" data-attributes="member: 52373">Good morning.&nbsp; I started looking at the diseqc motor control last night in the TV Engine 0.3.&nbsp; (Made it that far without the need to post anything<img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite8" alt=":D" title="Big Grin&nbsp; &nbsp; :D" loading="lazy" data-shortname=":D" /> ).&nbsp; When selecting my card (skystar 2 at the moment), there are three tabs.&nbsp; One is diseqc setup, the next is motor, and the third is scanning.I have read this thread (specifically frodo's post regarding the steps in what order to do things) <a href="https://forum.team-mediaportal.com/diseqc_motor_support-t14244.html?t=14244" target="_blank">https://forum.team-mediaportal.com/diseqc_motor_support-t14244.html?t=14244</a>&nbsp; This makes sense.However, I'm confused about how a guy can have C band and Ku on the same rotor?&nbsp; I see that I can select a satellite in the motor tab, but when I go to scan it, how does the application know what type of LNB to use?&nbsp; For example Galaxy10R at 123W.&nbsp; This bird has C band and Ku.&nbsp; My dish is connected to a diseqc positioner (36V positioner box (VBoxII)).&nbsp; The LNBF is switched from C band to Ku via 22KHz tone (this is a built-in function of the LNBF (BSC621) that I'm using).&nbsp; If I move the dish to Galaxy10R, store it as position#1, and then tell it to scan; how do I know what it is going to scan?&nbsp; <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite5" alt=":confused:" title="Confused&nbsp; &nbsp; :confused:" loading="lazy" data-shortname=":confused:" />&nbsp; Where does it pull the LNB info from?</blockquote>

[QUOTE="Das Hammer, post: 157110, member: 52373"] Good morning. I started looking at the diseqc motor control last night in the TV Engine 0.3. (Made it that far without the need to post anything:thx: ). When selecting my card (skystar 2 at the moment), there are three tabs. One is diseqc setup, the next is motor, and the third is scanning. I have read this thread (specifically frodo's post regarding the steps in what order to do things) [url]https://forum.team-mediaportal.com/diseqc_motor_support-t14244.html?t=14244[/url] This makes sense. However, I'm confused about how a guy can have C band and Ku on the same rotor? I see that I can select a satellite in the motor tab, but when I go to scan it, how does the application know what type of LNB to use? For example Galaxy10R at 123W. This bird has C band and Ku. My dish is connected to a diseqc positioner (36V positioner box (VBoxII)). The LNBF is switched from C band to Ku via 22KHz tone (this is a built-in function of the LNBF (BSC621) that I'm using). If I move the dish to Galaxy10R, store it as position#1, and then tell it to scan; how do I know what it is going to scan? :S Where does it pull the LNB info from? [/QUOTE]

Verification