Reply to thread

Message

<blockquote data-quote="gusangora" data-source="post: 362797" data-attributes="member: 17900">I have now uninstalled PDVD8 and installed SAF (including the PDVD8 codec).I can now play the networked movie/DVD folders, and navigate the menus using EVR. Must have been some issue with PDVD8 not allowing access to the networked movie folders (although mkv and avi were fine). However, as soon as I stop playback of the DVD, I get an error message stating that MP has stopped working. MP continues to be active but this message is permanently on screen. I can still watch movies, change to tv series etc until I click the error message. How to prevent this message?Also, I now have an issue with audio on avi files (mkv no problem). When I render with graphstudio (example attached) and play, the audio is good and shows on my receiver as 5.1 audio. When I play via MP, the audio is very, very low and displays on the receiver as 2.0 - this is the same when I select the automatic decoder option within MP. How can I see which decoders MP is using? (I tried asking graphstudio to connect to a remote graph, I click connect but nothing is displayed).</blockquote>

[QUOTE="gusangora, post: 362797, member: 17900"] I have now uninstalled PDVD8 and installed SAF (including the PDVD8 codec). I can now play the networked movie/DVD folders, and navigate the menus using EVR. Must have been some issue with PDVD8 not allowing access to the networked movie folders (although mkv and avi were fine). However, as soon as I stop playback of the DVD, I get an error message stating that MP has stopped working. MP continues to be active but this message is permanently on screen. I can still watch movies, change to tv series etc until I click the error message. How to prevent this message? Also, I now have an issue with audio on avi files (mkv no problem). When I render with graphstudio (example attached) and play, the audio is good and shows on my receiver as 5.1 audio. When I play via MP, the audio is very, very low and displays on the receiver as 2.0 - this is the same when I select the automatic decoder option within MP. How can I see which decoders MP is using? (I tried asking graphstudio to connect to a remote graph, I click connect but nothing is displayed). [/QUOTE]

Verification