Reply to thread

Message: <blockquote data-quote="edsche" data-source="post: 1169462" data-attributes="member: 28762">These jst connectors are easy to solder. My main problem was the soldering of the 0,75 mm2 cables to the mid of each stripe. They are too big for the little soldering points on the stripe. I think that is not the ideal solution. But with a big soldering point this will work too. Also I've soldered a little board where all parts come together and this board is then again connected to the pi. Maybe you should buy also a board. This makes everything easier to setup.</blockquote>