Reply to thread

Message

<blockquote data-quote="bsunders" data-source="post: 663242" data-attributes="member: 100981">Hey,I also grab Oz EPG from the DVB-T stream. I went through the same as some of the folks above - in the end I had to delete all channels and rescan to get the new names - also had to make sure all channels were ticked as EPG enabled. So now I do have most EPG data across all current Aussie channels. But since the new channels came about (and I upgraded to MP 1.1.1.) I am finding there are still some random holes in the guide which I never used to have.&nbsp; I did set the options to try and fill holes , and have clicked the manual EPG refresh a few times (Note: this according to the help will delete existing data for all channels and regrab - and does not just grab the selected channel).Currently for example I have some holes in channel 9 and Gem from 9am - 12 am - but after that fine - either there are holes in the source data or perhaps a config issue at my end.&nbsp;&nbsp; What do others have set for the EPG CRC ?? Is this needed ?&nbsp; BTW, this is a relatively minor issue, but the impact is that in the full guide, I cant easily select the channel where there is a gap.The config says allows you to set when the EPG is grabbed - but its hard to know when / if this is happening and with what success&nbsp; w/out using manual control.Ben</blockquote>

[QUOTE="bsunders, post: 663242, member: 100981"] Hey, I also grab Oz EPG from the DVB-T stream. I went through the same as some of the folks above - in the end I had to delete all channels and rescan to get the new names - also had to make sure all channels were ticked as EPG enabled. So now I do have most EPG data across all current Aussie channels. But since the new channels came about (and I upgraded to MP 1.1.1.) I am finding there are still some random holes in the guide which I never used to have. I did set the options to try and fill holes , and have clicked the manual EPG refresh a few times (Note: this according to the help will delete existing data for all channels and regrab - and does not just grab the selected channel). Currently for example I have some holes in channel 9 and Gem from 9am - 12 am - but after that fine - either there are holes in the source data or perhaps a config issue at my end. What do others have set for the EPG CRC ?? Is this needed ? BTW, this is a relatively minor issue, but the impact is that in the full guide, I cant easily select the channel where there is a gap. The config says allows you to set when the EPG is grabbed - but its hard to know when / if this is happening and with what success w/out using manual control. Ben [/QUOTE]

Verification