No more fullscreen pictures in RC1 (1 Viewer)

[savaino]

Hi,
I just updated with a ful install (including xp) from version 0.2.2.0 to 0.2.3.0 RC1 and with previous version I was able to watch 16x9 pictures in full screen.
Now I see the pictures with balck bars bottom and to the side.
I have a Hd 720p 16x9 plasma connected via vga.
I did not remember of any settings I did at the time of the 1st installation.
Any help will be appreciated!
--sav

 

[oljoooge]

Same Problem here with RC2 on a Plasma (1024x768) connected via DVI. There are black bars all around the picture :-( So the picture only uses 70% of the Display !

 

[mbuzina]

Try Configuration / Calibarate Screen. Then you may move the used screen "realestate" and correct borders. If that is not helping, please post a log.

 

[oljoooge]

Here we go...logs and screenshot attached.

This is no problem of Border-calibration...this must be something else...

Perhaps this thing with pixel aspect ratio...I have to adjust them to 1.33 to get a perfect square?!